Xx_jet_xX - 4-24-2004 at 07:42 PM
I dont know if anyone else has done this for tunnels or bridges... but if you want them to be even theres an easy way of doing it.
You put all your tunnels where ya want em, open the attrib for the entrance. click absolute z, subtract 8 from the first number. write this down
(both sets), then select all your tunnel pieces.... but not the entrance.open the atributes select absolute z then change it to the number you wrote
down. click ok, then click the deselect all button. and then uncheck the absolute z button on the side. its easier than the tunnel tutorial and you
only need a first grade education lol.
yep its pretty simple
perigrine falcon - 4-25-2004 at 02:39 AM
everything is in 8M Z increments every lower level is 8M less than the last i rarly use anything other than absolote Z unless im on flat terrain
tunnels snap to a 2M or 4M grid its easier to line them up that way
when making tunnels dont forget to set tunnels to a blink group and the entrance to a blinkgroup parent
Xx_jet_xX - 4-25-2004 at 05:59 PM
its easier to set your height this way than to do it like the tunnel tutorial explains. and ty for reminding me about blink groups lol, in the
tutorial it didnt explain what to do if your first number ended up as 0, you cant subtract nothing! this also works great for setting multiple bridges
over uneven ground.